ARDUINO MEGA 2560 PIN MAP SERIAL
ARDUINO MEGA 2560 PIN MAP UPDATE

The second one is a not connected pin, that is reserved for future purposes. In future, shields will be compatible both with the board that use the AVR, which operate with 5V and with the Arduino Due that operate with 3.3V.

1.0 pinout: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board.

Revision 3 of the board has the following new features: Revision 2 of the Mega2560 board has a resistor pulling the 8U2 HWB line to ground, making it easier to put into DFU mode. Instead, it features the ATmega16U2 (ĪTmega8U2 in the revision 1 and revision 2 boards) programmed as a USB-to-serial converter. The Mega2560 differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. If using more than 12V, the voltage regulator may overheat and damage the board. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. The board can operate on an external supply of 6 to 20 volts. Leads from a battery can be inserted in the Gnd and Vin pin headers of the POWER connector. The adapter can be connected by plugging a 2.1mm center-positive plug into the board's power jack. The power source is selected automatically.Įxternal (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The Arduino Mega can be powered via the USB connection or with an external power supply. Pin Mapping: PinMap2560 page Summary Microcontroller Schematic: arduino-mega2560_R3-schematic.pdf Schematic, Reference Design & Pin MappingĮAGLE files: arduino-mega2560_R3-reference-design.zip

ARDUINO MEGA 2560 PIN MAP UPDATE

The Mega 2560 is an update to the Arduino Mega, which it replaces. The Mega is compatible with most shields designed for the Arduino Duemilanove or Diecimila. It contains everything needed to support the microcontroller simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.

MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.

ARDUINO MEGA 2560 PIN MAP SERIAL

It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 The Arduino Mega 2560 is a microcontroller board based on the ATmega2560( datasheet).

Arduino mega 2560 pin map